Feeds:
Posts
Comments

Archive for July 5th, 2012

Kusha-esque

I’m always fascinated by the Habu Textiles stand when I see it at knitting shows, and their yarn with a very thin stainless steel core had intrigued me for ages before I bought a cone of it at the Ally Pally show, back in 2010. There was a pattern with it, for a scarf, but I only did a few rows before I decided that it was just too thin to enjoy working with it on its own, plus I didn’t like the fabric it was producing.

057 (2)

I looked on Ravelry, and found that there was another pattern for a similar scarf, but worked with another strand, of merino. So I pulled it out, and at the Harrogate show later that year, I bought the required merino, and another cone of the wool and stainless steel. Then put it all in a cupboard and forgot all about it. Which isn’t like me at all, obviously.

P1030144

But then a couple of months ago there was a thread on one of the Ravelry forums about the stainless steel yarn, and it prompted me to pull it out and have another go with it. The pattern most people use is Kusha Kusha, which starts with a decrease section with both yarns held together, then carries on with both yarns for a while before switching to just the stainless steel one and decreasing needle size. All of which sounded a bit unnecessary to me, so I used both yarns all the way, and increased at the end to match the beginning.

P1030145

The fabric was still a bit coarse (someone at Knit Night said it looked like chain mail, which almost put me off the whole thing!) but the pattern said to felt it slightly when you were done. I really should have done a swatch and felted that, if only to reassure myself, but whilst I’m a firm believer in swatches for garments, I pretty much always just wing it with everything else, so I didn’t.

P1030478

When I started this I envisaged it as a reasonably long term simple project, that I could take along to Knit Night or do in front of the tv, but once I’d started I somehow couldn’t stop, and it was finished in no time. Not knowing how much it would shrink when felted, I guessed at a bit taller than me (very scientific!) and this is what it looked like when I cast off.

P1030483

And this is it after felting! I did it by hand, with a bowl of water as hot as I could get it from the tap, and a bowl of cold. I’d dip it in the hot (with rubber gloves), then into the cold where I’d rub it about a bit, then repeated that a few times till the edges started to felt. To dry it I laid it out flat, then pulled the edges into soft points all the way along.

P1030518

And this is the finished product! It’s rather different from anything else I’ve made, but I do like it. The stainless steel in the yarn is fun, in that you can shape it a bit – if you crease it it stays creased, and it has a bit of body to it.

P1030524

The felting process has softened up the fabric considerably too – it looks much less like chain mail now!

P1030482

One problem I did have was with knitting from cones – I mostly knit on the sofa, with my ball of yarn to my right, between me and the back of the sofa (and my legs up on the sofa in front of me), but that didn’t work with cones, they just kept rolling around and I was afraid of snapping the yarn if I pulled. So I used an old pair of straight needles and a basket to rig up a sort of lazy kate for cones (they were about half an inch too big for the kate I use for plying when spinning!)

P1030519

P1030522

Read Full Post »